Four Channel Temperature Alarm Docs

The temperature in a pipe is monitored with four RTD Pt-100 Sensors, The type of probe could be Extruder RTD probes with Bayonet or Compression Fitting, Get it from Omega. To keep costs low you can choose small thin film RTD sensors, they will be fast but on rough usage may break.

Design Documents

Source Files Orcad Format

The time taken to measure the temperature at the 4 points will be less than 4 seconds. An optional display of the measured temperature as shown above can be avoided by using a DMM to adjust the setpoint.

The Analog Timer Module can be set from 0- 30 minutes. If out-a remains high even after set time a out-b alarm goes on to sound a buzzer and flash a LED light.

Block Diagram :


Four Channel Temperature Alarm

It all started with a email from a client like this ……….

“I am looking at an idea for a circuit design; The idea is to sense a temp of 130 degrees and then light an LED and start a timer delay. The delay would be 3 min, after the delay if the temp is still above 130 sound alarm.

With the LED I would like to drive a counter display to show how many times the temp was sensed. I would like powered by 120vac and a 9 volt battery backup for counter circuit. If you can assist please let me know.”

About delabs

delabs is a web-service for product design and development.
Tagged . Bookmark the permalink.

Comments are closed.