Constant LED Brightness and LDS8711

The LDS8711 is a fixed frequency current mode boost converter with internal rectifier and cycle-by- cycle switch current limit specifically designed to drive a string of up to 10 White LEDs.

Constant LED Brightness and LDS8711

Aa Switching Converter Chip with hardly any external components driving a HB LED chain. HB – High Brightness LED. This IC is from IXYS Power Devices.

High efficiency boost converter with the input voltage range from 2.7 to 5.5 V . Drives one LED string with 10 LEDs in series up to 32 mA.

  • 250 mV current sense voltage
  • No external Schottky Required
  • 0.7 MHz Switching Frequency
  • Efficiency greater than 83%
  • PWM LED Brightness Control
  • Low Shutdown Current (<1µA)

LED Current Setting – The maximum current value in the LED string may be factory preset in the range from 10 to 30mAin 0.125mA steps, or set by Smart OneWire interface in the range from 0.125to 32 mA.The average LED string current that determines LED brightness may be controlled applying PWM signal to the EN/PWM pin.

  • Sequential Timer – Pressure Switch
    This was built in a 96 X 96 Cabinet. It takes the process thru three timer delays and the pressure is measured after a certain [...]
  • Measurement Basics at National InstrumentsMeasurement Basics at National Instruments
    For an T&M Learning, Start with these tutors of NI. Like Analog Amplifier Circuits and Analog RC Filters. RF and Microwave Fundamentals if you want [...]
  • Programmable Logic Controller – PLC System
    TheLearningPit – PLC Simulators and Resources for Training. PSIM …. The Original PLC Simulator / Emulator – Proffessor Bill’s Free PLC Simulator! – Allen Bradley [...]
  • Analog Devices – Embedded Processors and DSPAnalog Devices – Embedded Processors and DSP
    They develop Analog Semiconductors, Digital Signal Processing, high performance signal processing solutions. Broadband Products, RF/IF Components, Embedded Processing and DSP. Analog Devices – Embedded Processors [...]
  • Facts of EMI and RFI from the InsideFacts of EMI and RFI from the Inside
    Electromagnetic interference (or EMI, also called radio-frequency interference or RFI when in radio frequency) is disturbance that affects an electrical circuit due to either electromagnetic [...]
  • EMAC – Semicustom Embedded Engineering
    Hardware design of digital, analog and microprocessor based circuitry. Circuits containing programmable logic or even ASIC’s can be developed. EMAC – Semicustom Embedded Engineering Semi-Custom [...]
  • Interactive Examples and Exercises – Jim SvobodaInteractive Examples and Exercises – Jim Svoboda
    James A. Svoboda – ECE Department, Clarkson University has created numerous interactive examples throughout the textbook – Introduction to Electric Circuits. Interactive Examples made of [...]
  • Temperature Measurement and Control
    These are documents and circuits which will help learn Basic Temperature closed loop control, There are many ways to control temperature. ON-OFF Hysteresis or Dead [...]
About delabs 548 Articles
delabs is a web-service for product design and development.

Be the first to comment

Leave a Reply