PowerEsim – Online power supply design

PowerESIM is a eCAD tool for switching power supplies on the Internet. Web Based Switching Power Supply design and Simulation.

PowerEsim – Online power supply design

The most important characteristic powerEsim is that it provide a virtual laboratory environment for engineer to verify and fine tune their design. Experience engineer use it to optimize their design by saving a lot of time than in real bench.

The circuit simulator is a combination of iteration, equation based apporoach and time step integration. The circuit is defined by non-linear equations and the simulator will first solving the switching condition solution for t=infinity by bracketed iteration, then fine step of point by point results will be generated by those equations for V, I and loss analysis.

“In a real laboratory, engineers have the ability to feel the heat, measure the stress, wind real transformers and wait and see how long until the unit gets burned. With our seamless integration of a variety of tools such as thermal, MTBF, Life, DVT, Waveform, etc., users can now do the same things in PowerEsim virtual environment.”

  • Electronic Product Development – Fidus Systems
    High-speed Electronic Product Development (EPD) with extensive design experience in turnkey product development and technical knowledge in System Design and Architecture. Electronic Product Development – [...]
  • Desktop Computing FutureDesktop Computing Future
    Wish we could Stop making Desktop Computers that are Energy Guzzlers by 2020. The Laptop/Notebook Electronics Design Architecture could be Ported to the Desktop Computer [...]
  • TI – CC2511F32 – 2.4 GHz SOC with USB
    TI – CC2511F32 – 2.4 GHz SOC with USB 2.4 GHz Radio Transceiver, 8051 MCU, 32 kB Flash memory and full-speed USB interface. “The CC2511Fx [...]
  • Open ARM9 SBC
    Powerful Devices in small sizes are possible with ARM based devices. Handhelds, Netbooks, Robots and Small Machinery can integrate an ARM based SBC with Touchscreen [...]
  • Heathkits – Learning with Practical ElectronicsHeathkits – Learning with Practical Electronics
    Heathkit was a well known supplier of electronic kits from 1947 through the early 1990’s (although no new kits were developed after 1986). An incredible [...]
  • Robust Electronic Design – John R Barnes
    Robust Electronic Design – John R Barnes “As an engineer, I am always working on new things. So I am going to make some mistakes. [...]
  • Multi-Instrument Digital Assistant – PIC16F84A
    Multi-Instrument Digital Assistant – PIC16F84A “It contains four instruments in one unit: logic probe, single channel logic state analyzer, frequency counter and serial code receiver.” [...]
  • Thermocouple and Current Input Module
    This module converts J, K Thermocouple and 4-20 mA Inputs to 0-2V Full Scale. These can be used for any voltage input too. The RTD [...]
About delabs 661 Articles
delabs is a web-service for product design and development.

Be the first to comment

Leave a Reply